0656 FLOOR SANDING AND FINISHING - STAIN / FILLER / DECK FINISH

1. GENERAL

1.1 Scope

Supply and application of a colouring stain, grain filler or exterior deck finish to prepared timber. Product: Bona Deck Guard (waterborne-1k).

1.2 Referenced documents

• AS 3959 Construction in bushfire-prone areas (exterior decks where applicable).

• Manufacturer's TDS and SDS.

• Product Specifier Paragraphs: refer to attached PDF.

1.3 Compliance and certification

No third-party certifications published.

2. PRODUCTS

2.1 Stain / filler / deck finish

Product: Bona Deck Guard.

Chemistry: waterborne-1k.

VOC: per TDS g/L.

Colour / tint: per architect's selection from the manufacturer's colour range.

2.2 Substrate compatibility

Substrate not nominated; verify species compatibility against the Bona species x primer matrix before tender.

3. EXECUTION

3.1 Preparation

Sand final grit P120; water-pop if required by the stain TDS.

3.2 Application

Apply 1-2 x Deck Guard at 6.0-12.0 m2/L m2/L per coat. Overcoat with the specified Bona topcoat within the window stated on the TDS (typically 48 hours for DriFast Stain). Prime with the manufacturer's system: 1-2 x Deck Guard.

4. SELECTIONS

Complete the application schedule for each area of the project. Supporting documents (TDS, colour chart, SDS, certification PDFs, Specifier Paragraphs) are listed under Required attachments.

Room / Area	Substrate	Product	Sheen	Coats
[Insert area]	[Substrate]	Bona Deck Guard	[Sheen]	[n]

Warnings

Substrate not nominated; verify species compatibility against the Bona species x primer matrix before tender.

Required attachments

Bona Deck Guard TDS.pdf (tds)
Bona Deck Guard SDS.pdf (sds)
Bona Deck Guard Specifier Paragraphs.pdf (specifier)

Citations

Generated by Floors Sanding Australia — Architect Hub. Generator v1.0. Source: /architects/specify/.